How To Change Code On Door Lock Kwikset. You will hear one short beep. You'll find it just above the thumb switch.
If your old code still remains in the unit, you will need to perform a hard reset of the unit. Ensure the door is open. The kwikset smartcode deadbolt is a sleek and modern electronic lock designed to fit in almost any existing decor.
Table of Contents
How Do I Change My Kwikset Lock Code?
If programming is successful the keypad will flash green once, and you will hear one beep. You will hear one short beep. It must be between 4 and 10 digits.
Make Sure The Lock Is Unlocked And The Door Is Open.
To begin install the new door latch if you’re not using an existing one. Enter a master code (4 or 8 digits) and press the lock button on the keypad. Enter the 0000 programming code and then press the kwikset button once.
Repeat The Steps To Create A Unique Secret Passcode For Other Users.
Allowing you to lock and unlock, change pin codes and lock settings remotely. You'll find it just above the thumb switch. Press the program button twice, enter the same new code and then press the lock button once.
Press And Hold The Program Button For 30 Seconds Using The Smartkey Tool Or A Paper Clip.
Slide the latch into the door, making sure that the middle hole in the latch is centered within the hole in the door. A single beep will indicate that the lock is ready to accept your new code. Do not know how to reset master code for door lockj.
Install The Smartcode Smart Lock.
You will hear one long beep. While your door is open, lock it and enter your new user code to make sure it unlocks the door.for all programming sequences, success is indicated when the kwikset button flashes green 2 times and you hear 2 beeps.if unsuccessful, the kwikset button will flash red 3 times and you will hear 3 beeps.note: If it’s not, remove the latch and rotate the mechanism 180 degrees (while holding onto the actual deadbolt.
