How To Find A Stud In The Garage Ceiling. Finally treat the exposed drywall with undercoat then plain ceiling paint in white. However, if it sounds hollow, don’t fret.
If it doesn't find a joist, measure 24 inches from the wall and try that area instead. Alternately, pull the cover off an electric outlet or light switch and take a peek inside the electrical box. It is a garage, doesn't need to be perfect quality finish.
Table of Contents
If The Drywall Was Hung On Top Of Plywood With Nails Or Screws There's A Decent Chance Those Won't Align With The Studs, Which Is Why Your Magnetic Studfinder Could Lead You Astray.
Outlets are attached to studs. Stud finders measure density to find beams, so they don't work on popcorn ceilings. The plaster is hard to clean at any time, and is surprisingly heavy which can cause the ceiling to sag over time.
If You Don’t Have A Stud Finder, You Can Still Locate The Studs In Your Wall But You Need To Be.
With this technique, you must start in one corner and use a tape measure to mark 16 inches. As with the stud finder, you need to find the first stud. If it sounds hollow, continue to the next step.
Need Help Understanding The Stud Layout In My Garage Ceiling.
As stated above studs are typically set on 16″ inch centers but could be set at 18″ inch or. This method will require the use of a tape measure, small nail and a hammer. This is easiest to do in the corner of a wall or near outlets or switches.
Start By Taking A Closer Look At The Trim In The Room.
This wall is not an exterior wall. It is a garage, doesn't need to be perfect quality finish. If you come up empty, try measuring 24 inches from the center of the first joist.
Measure 16 Inches To The Side And Use A Magnet To Locate The Metal Bolts.
Baseboards, crown moldings, and shoe moldings are nailed to studs, so if you can spot the telltale dimple where a piece of trim is nailed, then you've probably found a stud. If it sounds solid, then you found the joist! When it lights up, it has reached the edge of a joist.
