How To Floss Teeth With Fixed Retainer. Run the floss threader through your dental appliance and into a gap. (see the picture below to see this step in action)
If the wire is glued to each individual tooth, you will need to pull the floss out, and then be inserted between each tooth. Once the floss is under the wire, it can be moved up and down the sides of the adjacent teeth to remove plaque. People who wear braces and fixed are at increased risk of tooth decay and gum disease because food particles become trapped in the bands and wires they wear.in addition, the cement used for bonding the braces and retainers to their teeth increases.
To Floss The New Type Of Fixed Retainer, Slide A Piece Of Floss Between The Teeth (Fig.3), Turn The Floss Around The Tooth Without Being Bonded (Fig.4), And Slide The Other End Of The Floss Into The Next Space (Fig.5,6).
Last slide the floss down past the wire and cross the ends of the floss (fig.7) and move back and forth (fig.'7 arrows). Slip the loop over your front bottom tooth. The first thing you need to do when you’re flossing with a permanent retainer is to get underneath the wire.
Super Floss Is Reinforced On One End So That It Is Easier To Poke It Through Your Teeth, Under The Retainer.
How to properly use a floss threader: Simple thread it into your bottom teeth, and floss. Make a loop with your floss at one end.
Run Approximately 5 Inches Of One End Of The Floss Through The Loop Of The Threader.
Huang says that lingual retainers for upper teeth or lower teeth, usually run about $850. Put one end of the floss. Push the needle piece of the threader in one of the gaps between your bottom teeth.
Permanent Retainers Are Used To.
Good edu piece on flossing under a retainer. When you hear a click, the floss should have slipped under the wire and rested along the gumline. Permanent retainer also know as bonded or fixed, its made of solid wire that is twisted to prevent or fit the shape of your teeth.
Read Down Below, Or There Is A Video At The End, Click Here To Jump To The Video.
If you have braces, a permanent retainer or a dental bridge, flossing and maintaining the area can be a challenge. Next, pass the stiff end of the floss threader between your teeth on the front of your teeth and then beneath the retainer wire on the back side of your teeth. Don’t floss between teeth too roughly as this can seriously hurt your gums.