close
close
How To Program A Key Fob Chevy Trailblazer

How To Program A Key Fob Chevy Trailblazer

How To Program A Key Fob Chevy Trailblazer

How To Program A Key Fob Chevy Trailblazer. Press and hold the unlock button on the driver’s side door, then turn your key to the “on” position. If the locks do not cycle,.

How To Program A Key Fob Chevy TrailblazerHow To Program A Key Fob Chevy Trailblazer
New key fob for Chevrolet Blazer 2002 keyless remote entry 15043458 FCC from www.keylessremotewarehouse.com

Ensure all car doors are fully shut, then insert the key into the ignition, but don’t start the car. Then press and hold the remote start button for at least four seconds on the key fob. The door locks will start to cycle to alert you the programming mode has begun.

You Will Need To Provide Documentation That You Own The Vehicle And Can Either Pick Up The Key From A Nearby Location Or The Key Can Be Sent To You In.

Make extra copies following above instructions for 1 working key *note… you will need to call the keyless shop to have an electronic chip key made by code and cut, in order for this to work. Perform steps 5 through 8 in fairly rapid succession. Once you release the unlock button, you will hear the door locks engage and then disengage.

See also  How To Increase Blood Oxygen Levels For Exercise

Here’s How To Perform A Chevy Key Fob Programming In Nine Simple Steps:

The interior lights and radio will come on, but the engine should not be ignited. The average price for these batteries is about $5. The local mazda car dealer wanted to charge me $180.00 for the fob/key unit plus cutting the key and the programming.

Manually Unlock Your Car Door With Your Chevy Key.

Hold down the power unlock button on the driver’s door panel continue to hold down until instructed to release in step 9. Turn the key back to the “off” position, then turn it to “on” and right back to “off” once again in quick succession. You can order one online here.

Then Press And Hold The Remote Start Button For At Least Four Seconds On The Key Fob.

On the chevy key fob, press and hold the “unlock” and “lock” buttons at the same time until you hear the door lock and unlock again. Put your key in the ignition. Let go of the unlock button.

Every Two Years Or So, Or When The Battery Is Low, You May Need To Change The Key Fob Battery.

Press and hold the unlock button on the driver’s side door, then turn your key to the “on” position. The vehicle remains secured when you have remotely started. Turn the ignition switch to the on position (as far as you can go without starting the engine).

See also  How To Program A Nissan Rogue Key Fob

Leave a Reply

Your email address will not be published.