close
close
How To Replace The Compressor Relay In A Refrigerator

How To Replace The Compressor Relay In A Refrigerator

How To Replace The Compressor Relay In A Refrigerator

How To Replace The Compressor Relay In A Refrigerator. Perhaps the most effective way to test the start relay is by performing a physical test. The compressor start relay includes an overloa.

How To Replace The Compressor Relay In A RefrigeratorHow To Replace The Compressor Relay In A Refrigerator
HQRP QP24R7 4.7 Ohm 3Pin PTC Starter / Start Relay Replacement for from www.walmart.com

This is a video showing you how to install a 3 in 1 start relay. This is an electrical switch that tells the compressor when to turn on or off depending on the need for cool air inside the unit. Allow the refrigerator to run for a few hours while you monitor it.

Allow The Refrigerator To Run For A Few Hours While You Monitor It.

The compressor is labeled a, the relay is located in the terminal box which is located at the position labeled b. Before replacing the compressor relay, unplug the refrigerator to. The compressor start relay includes an overloa.

See also  How To Remove Ice Maker From Samsung 4 Door Refrigerator

How To Replace A Compressor Start Relay.

If this sound never happens and the temperature inside the fresh food compartment and the freezer begins to. The compressor relay can be accessed by removing the terminal cover box. If the compressor starts and runs, the old relay was malfunctioning.

Following The Wiring Code Provided By The Refrigerator Manufacturer, Attach The Wires On The Capacitor To The New Compressor.

If there is not, change the relay and repeat step 1. Without a refrigerant, your compressor won’t function well. You should hear a click when putting back on the metal hinge.

To Test The Compressor Of A Maytag Refrigerator, Pull Out The Start Relay From Its Side.

First, remove rear access panel. The decision ultimately comes down to. The next step is that plug the wire into your new refrigerator compressor relay and put the relay into the connector of the old relay.

When You Do This, You Will See 3 Pins Or Terminals On Which The Relay Rests Or Is Plugged.

Use this repair procedure to replace the compressor start relay in kenmore, frigidaire, electrolux, whirlpool, kitchenaid, maytag, amana, ge, samsung, lg, gibson, crosley, bosch and haier refrigerators. These two steps must be done at the same time in order to work. Remove the old compressor start relay.

See also  How To Remove Ice Maker Tray From Samsung Refrigerator

Leave a Reply

Your email address will not be published.