close
close
Raptor 660 Starter Clutch Removal

Raptor 660 Starter Clutch Removal

Raptor 660 Starter Clutch Removal

Raptor 660 Starter Clutch Removal. Could the starter be bad. Maybe the gear is heat treated and hardened.

Raptor 660 Starter Clutch RemovalRaptor 660 Starter Clutch Removal
Raptor 660 one way starter clutch issuse Yamaha Raptor Forum from www.raptorforum.com

If that does not spin it you will need to get that starter out to bench test it. Then clean up all parts, for reinstallation. Put your ground wire in position, replace all the bolts and tighten to 7.2 ft/lbs or 10 n/m.

Take A Tap, Clean The Threads In The Magnito, And Take A Dye, Clean The Lock Tight From The Allen Bolts.

Once all are loose, remove them. Remove four bolts to the starter idler cover. To yamaha 1yr warranty warrior 88~04 raptor 05~12 yfm 350 starter clutch kits.

I Definately Agree That It Sounds Like Your Starter Clutch Is The Problem.

Remove the left case cover. Remove the small idler gear and set aside with the cover. 1 remove four bolts to the starter idler cover.

See also  My Hero Academia Movie 3 Release Date In Netflix

Yamaha Raptor 660 One Way Bearing Starter Clutch Gear Kit 2001 2002 2003.

I just replaced the starter clutch in my 660r raptor and it’s still making the same binding/meshing noise as before i changed it. Maybe the gear is heat treated and hardened. My question is will a bad clutch cause a raptor 660 to lunge forward and stall out when put into first gear.

Make Sure The Battery Is Fully Charged Or Put A Jump Pack On It.

1/2 breaker bar with 1/2 socket, 8mm socket 8mm open/box wrench, ratchet, 19mm or 3/4 socket, 5mm hex wrench, strap wrench, steering wheel (or similar) puller. You can get away with using regular generic pullers sometimes, but i have personally seen flywheels ruined by using the wrong tool. #9 · jan 27, 2019.

It Just Pulls Strait Out No Tricks If It Is Jammed You Will Have To Sort Out Why.

Nothing really informative to see but posted up for the hell of it to go with the other 2 vids about installing a new one. If you don't have access to air tools for disassembly, just hold the flywheel with the strap wrench as tight as you can, put the socket and ratchet on the nut and hit the ratchet with a hammer. Then clean up all parts, for reinstallation.

Leave a Reply

Your email address will not be published.